Toyota Celica 1987-1993

Headunit Installation Requirements

You will need

Facia - Single DIN : 

Required

Steering Wheel Control Harness: 

Not Required

Primary Harness: 

Required, may require a secondary harness

Antenna Adaptor: 

Not Required

Additional Products

Antenna: 

Not Available

T Harness (for adding aftermarket bluetooth car kits): 

Available
Images
About this Vehicle

Dates: 

Jan 1987 through Jan 1993

Manufacturer: 

  • Toyota

Sub-Model: 

ST162/ST184R

Chassis Type: 

  • Coupe
  • Hatchback

Place of Origin: 

Japan

Tags: 

  • Toyota
  • Celica
  • ST162
  • ST184R

Toyota Celica

The Australian spec Celica ST162 were the base model ST with 3S-FE engine offered as Coupe and Liftback, and the top of the line SX Liftback with higher performance 3S-GE Twincam engine. Rear spoiler and alloy wheels came standard on the SX, which made it the same appearance as the Japanese GT-R or American GT-S. The limited edition SX White Lightning with all white bumpers, side protectors and wheels was offered in 1989.

The ST184R model for Australia were SX Coupe, SX Liftback, GT-Four, and also 150 units limited edition GT-Four Group A Rallye. The Australian cars are less luxurious than JDM and North American models. Initially, the GT-Four did not come with ABS and fog lamps, which became standard few months after the introduction. In 1993, the Limited Edition WRC Trophy model was offered in Australia. This is basically the SX with sport front seats from the GT-Four, cruise control, rear window shade / spoiler, and special decals. It was face lifted in 1991.

Information provided by: http://en.wikipedia.org/wiki/Toyota_Celica#Australia

Speaker Cavities
Dash: 4"
Front: 6-1/2"
Rear: 6-1/2"